[an error occurred while processing this directive]
Posted by Dave on May 02, 2006 at 12:04:34:
In Reply to: Re: question regarding Ergomax repipe posted by HeatPro on May 02, 2006 at 10:52:39:
: So he wants to take a pipe off a 1-1/2 pipe and put it in a 3/4" pipe, instead of where it was planned.
+++ Maybe I didn't explain it right....he would take the 1.5" return header and split it into two separate 1.5" pipes with a 1.5 x 1.5 x 1.5 tee to make a kind of manifold. He then would take the 2 1.5" legs and attach them as follows....Right at the temp connection, one of the 1.5" legs would be reduced to 3/4" and attached there. The other leg would be reduced right to 3/4" at the PRV valve and attached there. So, the 1.5" header would essentially become 2 3/4" legs. Temp gauge anfd PRV would be attached to tees above these connections.
Does that make sense?