[an error occurred while processing this directive]

Wiring Honeywell V8043E with taco 007 and Honeywell RA832A Relay

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #3 ] [ FAQ ]

Posted by Chris on September 17, 2006 at 22:26:02:

Hello,
I am nearing the end of adding radiant heat to an existing two zone gas fired hot water boiler. The original two zones operate with zone valves with one circulator. On the new project, I have three radiant heat zones with three zone valves and one circulator. I want to run all three zones through a single relay. Any thermostat calls for heat, the zone valve opens and it trips the circulator. It is not a cold start boiler. My question is this.... How do I wire this? The zone valves have two yellows and two reds. The zone valve directions only point to replacing an existing valve, not installing a new one. Thanks in advance for your help
Chris


Follow Ups:


Post a Followup

Name:
E-Mail:

Subject:

Comments:

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #3 ] [ FAQ ]