[an error occurred while processing this directive]
Posted by chris on September 18, 2006 at 18:50:33:
In Reply to: Re: Wiring Honeywell V8043E with taco 007 and Honeywell RA832A Relay posted by HeatPro on September 18, 2006 at 11:20:31:
Thank you for your reply (re:zone valves)
Funny you should say that I should use a Taco ZV relay box as that is what I bought today (SR501-1). As I look at it, I think I am stuck on stupid. The Panel looks like this
R W
T T
Both have screws underneath the Ts. This is where I get confused. I understand that the reds go to T and T and I am to hook the yellow to the 24vac. There is a transformer built into the box, so there is no wire that goes to R. If I hook up the yellow to W does that mean I am securing it to the same screw as one of the reds on the T?
Thanks for your help, you are starting to paint a picture.
Chris