wiring of off-delay timer

Posted by Dave on May 05, 2006 at 16:57:56:

Heatpro,
I had purchased the Issc 1081 timer to run my boiler circ for a minute or 2 after the call for heat ended to pull any excess heat from boiler heat exchanger to Ergomax
I spoke with the tech rep this morning and he had said to apply 120 v input power to terminals 7 and 2.
He then said I should wire the pump (120 V)to NO terminals 6 and 8.
Before I hooked the pump to it, I used my voltage tester, and that does not make sense. I get no power anywhere except between terminals 7 and 2.
Here is the datasheet:

http://www.issc-kanson.com/datashts/1081.pdf

I was going to take the hot wire from the boiler and attach to 7 and neutral from boiler to 2. THen hot wire to pump on 6 and neutral to pump on 8.
Would you be able to tell me how it should be wires? Technical is closed until Monday.
Thanks.
Dave

Follow Ups:

• Re: wiring of off-delay timer HeatPro 20:17:43 5/05/2006 (0)
• Re: wiring of off-delay timer Dave 17:57:54 5/05/2006 (5)
  • Re: wiring of off-delay timer HeatPro 20:24:44 5/05/2006 (4)
    • Re: wiring of off-delay timer Dave 22:34:58 5/05/2006 (3)
      • Re: wiring of off-delay timer HeatPro 00:15:05 5/06/2006 (2)
        • Re: wiring of off-delay timer HeatPro 08:28:29 5/06/2006 (1)
          • Re: wiring of off-delay timer Dave 09:47:34 5/06/2006 (0)

Post a Followup