[an error occurred while processing this directive]
Posted by Dan on April 27, 2010 at 08:07:24:
In Reply to: Re: direct vent exhaust blistering paint posted by Heatpro on April 26, 2010 at 19:55:03:
Here are a couple photos. The manufacturer says that the outer pipe with insulation is fine the way it is. The termination is 9.5" x 9.5". I found a 10" x 10" cake pan. I was also going to place some heat proof silicone against wall. I will screw cake pan to wall and then termination to that. I was also going to use high temp silicone caulk between large pipe and siding as well as between small inner pie and cake pan. What do you think? Would you also cut shingles maybe an inch from outer tube? Thanks.
Post a Followup