[an error occurred while processing this directive]

Re: Normal Boiler Pressure Range

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #4 ] [ FAQ ]

Posted by Steve R. on March 13, 2008 at 20:22:59:

In Reply to: Normal Boiler Pressure Range posted by Ziad on March 11, 2008 at 21:14:59:

: I have a 1983 Burnham boiler that has been recently moved in the basement. The old steel expansion tank has been replaced with a bladder type expansion tank (Flexcon HTX 60) mounted on an air scoop and vent on the supply side of the boiler.
: I am concerned about the operating pressure of the boiler which reaches a maximum of about 24 psi when the boiler has been continuously only for a couple of hours. The boiler water temperature gage reads 170-180 F at the high point. When the boiler is cold, the pressure is set at 12 psi. The expansion tank is new and was properly pre-pressurized to 12 psi.
: The expansion tank was sized properly for a boiler of about 100k BTU/Hr and cast iron radiators.
: All radiators in the house (2 stories above basement), get properly hot.

: Is it OK for the boiler to reach a pressure of 24psi when the relief valve is set to open at 30? People suggest pressure ranges between 12 and 15 it seems.

: What else could cause a pressure increase like that?

: My plumber and I are at a loss. Any information would be very helpful.

: cheers,
: ziad

Follow Ups:

Post a Followup




[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #4 ] [ FAQ ]