Re: Is AL294- c For Air intake necessary

Posted by Bernie on July 18, 2006 at 12:44:04:

In Reply to: Re: Is AL294- c For Air intake necessary posted by HeatPro on July 18, 2006 at 11:54:17:

: : Why is it necessary to use AL294-c for the air intake on a burnham revolution boiler?

: ++ If they say it is necessary, then it is necessary. Whatever the manufacturer says in the instruction manual is code, unless the local code official over-rules the manual.

: However, the instructiuons ar:
: http://www.burnham.com/pdfs/CurrentPDFfiles/REV_I&O.pdf
: show alternate methods of installation, including use of B-vent as an intake sleeve and power vent where the air is taken from within the building. So, depending upon approval from Burnham, intake venting might not be required at at all.

Thanks for your time but it seems like a huge waste of money for a pipe providing cold air.
Some times they say its necessary because they make the pipe too..

Follow Ups:

• Re: Is AL294- c For Air intake necessary HeatPro 13:23:28 7/18/2006 (4)
  • Hold everything you can use PVC for the vent. Bernie 16:17:11 7/18/2006 (3)
    • Re: Hold everything you can use PVC for the vent. HeatPro 20:53:35 7/18/2006 (2)
      • Re: Hold everything you can use PVC for the vent. Bernie 10:31:11 7/20/2006 (1)
        • Re: Hold everything you can use PVC for the vent. HeatPro 13:32:18 7/20/2006 (0)

Post a Followup