HeatSponge Boiler Economizers
"Saving The World From High Fuel Costs"
Natural gas will never be inexpensive again making a boiler economizer more important than ever. HeatSponge offers products for boilers ranging from 50 HP to 150,000 pph. Improving boiler efficiency results in reduced pollution levels. Check how much money you can save by visiting our website. Click Here For On-Line Performance and Pricing.

Re: wiring boiler/ergomax in my situation

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]

Posted by Dave on February 07, 2006 at 08:16:25:

In Reply to: Re: wiring boiler/ergomax in my situation posted by HeatPro on February 06, 2006 at 18:37:52:

Thanks HeatPro. Do you have a link to a low voltage thermostat with floor sensor? I searched quite a few sites and found only line voltage for electric radiant.

You said to take the pump off the SR 504 and put on separate relay. In my current configuration (until it's repiped), you think the 007 for the floor would pull through the pipe without the boiler circ running? I think the problem is that the water will not return from the zone header into the boiler return pipe because the idle 0010 has a certain amount of backpressure.

Can I email you some pictures so that when we repipe, we can correct any other issues you might see presently?

Thanks.
Dave

Follow Ups:

Re: wiring boiler/ergomax in my situation HeatPro 09:21:30 2/07/2006 (2)
- Re: wiring boiler/ergomax in my situation Dave 20:32:21 2/07/2006 (1)
  - Re: wiring boiler/ergomax in my situation HeatPro 23:26:13 2/07/2006 (0)

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: Thanks HeatPro. Do you have a link to a low voltage thermostat with floor sensor? I searched quite a few sites and found only line voltage for electric radiant. : You said to take the pump off the SR 504 and put on separate relay. In my current configuration (until it's repiped), you think the 007 for the floor would pull through the pipe without the boiler circ running? I think the problem is that the water will not return from the zone header into the boiler return pipe because the idle 0010 has a certain amount of backpressure. : Can I email you some pictures so that when we repipe, we can correct any other issues you might see presently? : Thanks. : Dave

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]