[an error occurred while processing this directive]

Re: Spirovent placement


[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]

Posted by Dave on December 08, 2005 at 18:48:41:

In Reply to: Re: Spirovent placement posted by Heatpro on December 08, 2005 at 12:51:21:

OK HeatPro....I got him to delete the Spirovent. Now, as far as the placement of the air vent, can it go where we currently have an air vent at the capped end of the supply manifold (past all the zone pumps?) (This was shown in the original picture). It is the highest point in the manifold, and the horizontal steel pipe for the header does slope up to it slightly...Or are you referring to putting the vent at the top of the vertical pipe that currently runs from the boiler to the horizontal pump header? The top of that vertical pipe is not as high as where the air vent currently is.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]