[an error occurred while processing this directive]
Posted by ken lucas on April 13, 2009 at 09:32:52:
Have a 5 zone Beckett/Burnham system with above referenced relay. After a power outage the furnace did not restart. Pressed the manual restart button on the burner and it started and ran as usual. All zone valves functioned normal and burner shut down at high-end 180 degree setting - but burner then did not restart again when low temp range hit and thermostats callng for heat.
Replaced that relay about 6 yrs ago; system is 14 yrs old.
Is relay likely the culprit or should I look elsewhere first?
Post a Followup