[an error occurred while processing this directive]

Re: Heatmaker M2 HW 130


[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #4 ] [ FAQ ]

Posted by HeatPro on September 15, 2008 at 11:59:12:

In Reply to: Re: Heatmaker M2 HW 130 posted by Cam Greener on September 15, 2008 at 10:48:41:

it is starting a new burn cycle pre purge, but once the pre burn purge is complete is figures out that it doesn't need to burn since the water is already at temperature.

Ah yes. But if the low limit was satisfied by the water being hot enough at its higher end, yet, not as high as the high limit -
then what is it that is making the burner start again to rerun the purge cycle? It has to be one of the temperature sensors not detecting a satisfactory temperature due to mislocation, malfunction, or cooler currents at that location.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #4 ] [ FAQ ]