[an error occurred while processing this directive]
Posted by HeatPro on May 24, 2006 at 11:33:29:
In Reply to: Excessive soot build-up on heat exchangers posted by Art on May 24, 2006 at 10:43:00:
The flame looks good, but without pressure measurement to assure the right factory design pressure as on the label and CO testing to know if it is burning right, there is no assured way to adjust the flame to stop the problem.
It might be that the burner is in a location with something flying through the air to make ash, like pollen, grain powder, etc.
Post a Followup