[an error occurred while processing this directive]
Posted by joe matson on December 13, 2011 at 02:38:58:
we are getting fault #28 and prior fault #29.
both lock out boiler and are combustion errors,
fault #29 is for pilot, I want to start metering out circuits / relays but isnt there a quick way to go strait to that particulare interlock and go from there ?
our manual is a little iffy due to we now have the new [ hawk paenl ] which display a different fault code but if your lucky and catch it the fault codes for the 28-and 29 will appear on top of screen [ before ] acknowledging.
any advice will be appreciated. [ I know to start checking out the pilot etc---but usualy ise a quicker componet to check , relay etc---
Post a Followup