[an error occurred while processing this directive]
Posted by Dave on April 05, 2007 at 08:32:31:
We have a Lochinvar Efficiency+ gas boiler that is direct vent through the side wall of our house. Today I noticed it wasn't operating. The light that says "purge" on the controller was flashing. I shut off the boiler and let it sit for a few minutes, and when I turned it on, it ran fine. I just went downstairs and it is locked out again. I shut it off for a few minutes and when i turned it back on, it is running again. Serviceman came last night and said it was our Heatmanager, so he disconnected it. This morning....no heat. If I turn off power switch and then turn it back on, boiler fires immediately and runs through cycle without problems. Also seems to shut down properly. But when there is another call for heat, fans come on, but boiler will not fire unless I reset the power again.
Does anyone know why it would be doing this?
Post a Followup