[an error occurred while processing this directive]
Posted by HeatPro on August 20, 2006 at 12:50:53:
In Reply to: Worcester Bosch 24CDi RSF Problem posted by Mark Nolan on August 20, 2006 at 12:34:05:
As you are a registered Corgi, one can assume that you aren't replacing sensors or boards to no longer sense that the boiler made or makes steam. Steam release is a sign of inadequate water flow due to gas reg, pump or blockage. You are the only one so far with those readings of adequate flow due to adequate pressure, so no further judgement can be made. Thus, a board replacement might lower gas flow to the required amount for the water flow or not.
Post a Followup