[an error occurred while processing this directive]

Re: A bit of a haedache for my heating: new floors installed.

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #3 ] [ FAQ ]

Posted by HeatPro on May 21, 2006 at 11:49:21:

In Reply to: A bit of a haedache for my heating: new floors installed. posted by Vicki on May 21, 2006 at 04:39:03:

paint with aluminum or bronze radiator paint, if you can find it. I have never seen such paint peel. If you use any paint, thin coats are most important.

The other way: Scrape and peel off all paint that will come off, then spray on an HHR paint that comes in an aerosol can. The HHR stands for high heat resistant, which is probably necessary with the high heat of steam radiators. It is not needed for hot water system radiators.

Do not use latex paint on a warm surface.

The latex paint and primer could develop rust spots, and latex paints may not hold their color on a hot radiator. It is better to use an oil primer (Kilz is good), and an oil-based finish paint. Actually, you could use an aerosol spray enamel as a finish coat. Of course, be careful when spraying indoors. With care and practice it is possible not to get the spray paint all over the floor, walls, and anywhere else you don't want it.

http://www.epa.gov/seahome/leadenv/src/radiat.htm

A reclaim company paints radiators. One of the radiators is finished in red oxide primer, while the other two are finished in a clear powder coated lacquer.

Effect of Paint : http://www.jcgbs.com/users/jft/Radiator%20Color.htm

http://www.krylon.com/product/op_specialties.asp

http://www.stretcher.com/stories/00/001106p.cfm

http://www.art-restoration.com/press6.html : Years ago, when the gilding on antique mirror and picture frames became dull or darkened, the handyman of the family would visit the hardware store to buy a can of his favorite radiator paint. The choices for the "restoration" were silver or bronze. The radiator paint was great stuff. It wore well, covered the original gilding and didn't chip. Well, here we are at the start of the twenty-first century, and those antique frames with their radiator paint finishes intact are still coming through the door of the New Orleans Conservation Guild.

you can buy J-B Weld for about five bucks at most automotive and hardware retail stores.

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: paint with aluminum or bronze radiator paint, if you can find it. I have never seen such paint peel. If you use any paint, thin coats are most important. : The other way: Scrape and peel off all paint that will come off, then spray on an HHR paint that comes in an aerosol can. The HHR stands for high heat resistant, which is probably necessary with the high heat of steam radiators. It is not needed for hot water system radiators. : Do not use latex paint on a warm surface. : The latex paint and primer could develop rust spots, and latex paints may not hold their color on a hot radiator. It is better to use an oil primer (Kilz is good), and an oil-based finish paint. Actually, you could use an aerosol spray enamel as a finish coat. Of course, be careful when spraying indoors. With care and practice it is possible not to get the spray paint all over the floor, walls, and anywhere else you don't want it. : http://www.epa.gov/seahome/leadenv/src/radiat.htm : A reclaim company paints radiators. One of the radiators is finished in red oxide primer, while the other two are finished in a clear powder coated lacquer. : Effect of Paint : http://www.jcgbs.com/users/jft/Radiator%20Color.htm : http://www.krylon.com/product/op_specialties.asp : http://www.stretcher.com/stories/00/001106p.cfm : http://www.art-restoration.com/press6.html : Years ago, when the gilding on antique mirror and picture frames became dull or darkened, the handyman of the family would visit the hardware store to buy a can of his favorite radiator paint. The choices for the "restoration" were silver or bronze. The radiator paint was great stuff. It wore well, covered the original gilding and didn't chip. Well, here we are at the start of the twenty-first century, and those antique frames with their radiator paint finishes intact are still coming through the door of the New Orleans Conservation Guild. : you can buy J-B Weld for about five bucks at most automotive and hardware retail stores.

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #3 ] [ FAQ ]