[an error occurred while processing this directive]
Posted by HeatPro on October 30, 2005 at 19:00:59:
In Reply to: bleeding air out fo beckett af11 posted by dave on October 30, 2005 at 10:01:00:
http://www.suntecpumps.com/PDFs/Installation%20and%20Service%20Manual%20-%20Section%20IV.pdf
http://www.websterfuelpumps.com/trouble.htm
You would like to get the thing dependable. Unfortunately, to know when you have achieved that requires combustion test instruments, suction and pressure gauges, smoke testers and draft gauges. No matter how you turn the thing around and rationalize that it just requires you to put good parts in or just get air out, it always comes down to knowing the results of what you did and what the combustion characteristics are. There is no green light that comes on, nobody comes in the door and puts a sticky on the jacket and no letter comes to tell you that it is dependable - that comes from using the combustion test instruments and knowing when the unit will run because all the parts are the way the factory designed them to be and runs at the efficiency they designed it at.