[an error occurred while processing this directive]
Posted by Holly L on October 04, 2005 at 00:23:00:
I want to create two zones. I have a dunkirk hotwater zeb series boiler. I presently have 1 thermostat and one taco circulating pump. Thermostat (via wire) connects to a honeywell circulating relay. Also connected to the same circulating relay is 110 line voltage. Honeywell circulating relay connects to circulator pump (110v) and Honeywell combination limit and relay control(24 volt). If I install a second thermostat can I wire each thermostat to two new cooresponding zone valves. Then can I continue each thermostat wire from these zone valves to the one honeywell circulating relay?
Post a Followup