[an error occurred while processing this directive]

Re: banging


[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]

Posted by Harold hydronicnetwork.net on January 03, 2004 at 10:00:37:

In Reply to: Re: banging posted by eburke on January 03, 2004 at 09:12:33:

A cheap ball valve or gas cock is a quick test tool; but somewhat difficult to set and takes some time to get it set right.

You might try a vertical adjustable radiator vent. It would be small for a main when wide open; but might carry the load.

http://www.heat-timer.com/?page=varivalve

http://www.sidharvey.com/public/new_products.htm
(bottom)

You could use a B&G 1A on a reducer elbow on a nipple from the main also.

http://www.hoffmanspecialty.com/pdf/hs900/HS900-1A4070A.pdf





Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]