[an error occurred while processing this directive]

Re: Thundering noise from venting system

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]

Posted by JRD on March 27, 2004 at 16:24:38:

In Reply to: Re: Thundering noise from venting system posted by JRD on March 27, 2004 at 16:07:34:

Thanks for your reply.

Pre and post purge are both working OK.
I can control the loud noise a little by setting the air band on the burner to around 0.50 GPH. The spec calls for 0.60-0.65. It still has a loud rumbling noise during the electrode ignition and continues until the electrode shuts off.
I stated that the noise was coming from the venting system, but I beleive that it is the burner itself that makes the noise.
I think the only way that I can get this burner working right is to get the manufacturer to send a rep from there company. All of the technicians that have looked at it say that all of the setting are within spec.

Anymore suggestions?

Thanks, JRD

Follow Ups:

Post a Followup

Name:
E-Mail:

Subject:

Comments:
: Thanks for your reply. : Pre and post purge are both working OK. : I can control the loud noise a little by setting the air band on the burner to around 0.50 GPH. The spec calls for 0.60-0.65. It still has a loud rumbling noise during the electrode ignition and continues until the electrode shuts off. : I stated that the noise was coming from the venting system, but I beleive that it is the burner itself that makes the noise. : I think the only way that I can get this burner working right is to get the manufacturer to send a rep from there company. All of the technicians that have looked at it say that all of the setting are within spec. : Anymore suggestions? : Thanks, JRD

[ Follow Ups ] [ Post Followup ] [ Boiler Room Residential and Home Forum #2 ] [ FAQ ]