[an error occurred while processing this directive]

Re: flat glass water site gages


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 4 ] [ FAQ ]

Posted by LeoO on September 27, 2006 at 10:09:23:

In Reply to: flat glass water site gages posted by kraig on September 09, 2006 at 18:34:19:

I had a similar situation with my old 250# units and found that if the torque sequence on the glass/mica clamps is not followed very carefully, premature glass failure occurs.




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 4 ] [ FAQ ]