[an error occurred while processing this directive]
Posted by dave on February 02, 2010 at 16:27:56:
In Reply to: cb 70 controller code F68 posted by Nathan Bailey on January 27, 2010 at 08:06:36:
: hi everyone,
: i'm operating a cb600-250 scotch dry back with a cb70 controller. i've just finished the soak and neutralize portions of an acid wash and am now attempting to light off on low fire to aid in the blow down part of the wash. unfortunately it won't ignite and shows code F68. this is not listed in any of the books i have access to and the only reference found online is a question and reply in forum #2 here and of course the link is bad (damm hackers). if anybody out there is familliar with this piece of equipment and this code and can point me in the right direction i would really appreciate it.
: thanks,
: nat
.........pretty sure that is a bad controller but i will know more tomorrow i'm going to a location with those controllers it might also b a low fire switch not making its either one of those codes i will reply tomorrow and let u know