[an error occurred while processing this directive]
Posted by Terry on December 12, 2006 at 08:34:33:
In Reply to: Trianco-Heatmaker HW-M2 series posted by Terry on December 10, 2006 at 16:01:37:
: : Hello,
: I have a problem with my heatmaker HW-W2 series . The problem I have is that it doesn't call to heat the hot domestic water when it should. When the temp in the tank falls to 140 degrees the boiler should fire up and start heating the water but it doesn't. The temp will fall to 100 degrees and still the boiler doesn't fire up, only once in a while, so what I do is take the front cover off the unit and then take the cover off the pressure diferential switch and take a screw driver and touch the contact screw above the switch and then the boiler starts up. The computer board looks fine with little green light so is there any way to fix this problem?
: Could some one please help me with this dilemma?
: Let me know if you need me to be clearer on the subject. Thank you and best regards, TerryD.
Still waiting for some tech support on the subject, is this forum still active?
Post a Followup