[an error occurred while processing this directive]
Posted by Pete on November 10, 2003 at 15:34:20:
In Reply to: Combustion control of wood-waste & natural gas boiler posted by Cesar on November 10, 2003 at 10:44:20:
:Is your plant on dcs control?
Do you need to burn gas to support combustion?
I would strive to eliminate the use of gas altogether, only to be used as a back-up fuel. If you have dry wood waste this should be achievable.
If this is not possible, take the fuel flow controller out of the boiler master control loop. Run it at a minimum setting.
Post a Followup